Battery-GT3-AMR-GT3

🔧 How to Install (or Replace) the Segway GT3 Battery

Tools Needed:

• Allen wrench (usually included with the scooter)

• Replacement Segway GT3 battery

• Safety gloves (optional)

---

Step 1: Power Off the Scooter

Ensure your Segway GT3 is completely turned off and disconnected from any charger.

---

Step 2: Locate the Battery Compartment

The GT3 battery is typically located beneath the deck of the scooter. Flip the scooter gently onto its side or use a stand to expose the bottom.

---

Step 3: Unscrew the Battery Cover

Using an Allen wrench, remove the screws securing the battery cover. Carefully take off the cover and set it aside with the screws.

---

Step 4: Disconnect the Old Battery

Locate the battery connector. Gently unplug it. If there are any securing brackets or straps, unclip or unscrew them to fully free the battery.

---

Step 5: Remove the Old Battery

Carefully lift out the old battery. It may be slightly heavy, so use two hands for better control.

---

Step 6: Insert the New Battery

Place the new Segway GT3 battery into the compartment. Make sure it’s seated securely and properly aligned.

---

Step 7: Reconnect the Battery

Plug the connector from the scooter into the new battery. Ensure the connection is snug and fully inserted.

---

Step 8: Secure the Battery and Replace Cover

If there were any brackets or straps, reattach them. Then place the battery cover back on and screw it tightly into place.

---

Step 9: Power On and Test

Turn on the scooter to ensure the new battery is working correctly. Check for full connectivity and normal operation.

---

✅ Tip:

Always use an official Segway GT3 battery to ensure safety and compatibility. Improper installation or third-party batteries may void your warranty.